New Zealand Local Weather Forum

Weather Discussion => Hardware Software and Technology => Weather Display => Topic started by: Phil on November 26, 2013, 07:15:16 PM

Title: Davis Weather Station not receiving data
Post by: Phil on November 26, 2013, 07:15:16 PM

Help, the Davis Station showed that the batteries where low so I changed them but since then i cannot get data from the weather station, everything was working fine till I changed the Batteries, the console is picking up the weather station but not displaying on the console, the system is wireless, any ideas?

Title: Re: Davis Weather Station not receiving data
Post by: David on November 26, 2013, 07:53:36 PM

Did you change the batteries of the console, or the outside unit?

I would put the console into setup mode and then exit again. This makes the console try to re-establish contact with the sensors.
For a VP2 station, enter setup mode by pressing DONE and -  at the same time, and then exit by pressing and holding the DONE button.

Title: Re: Davis Weather Station not receiving data
Post by: Phil on November 26, 2013, 08:20:16 PM

Hi David, I changed the batteries in the console, Have done the exit by pushing done (tis a VP2 system) and nothing changed, the console is picking up the out door unit

Title: Re: Davis Weather Station not receiving data
Post by: David on November 26, 2013, 09:21:28 PM

Hi Phil, have you looked in the troubleshooting section of your VP2 manual? Maybe something there can help.

I haven't had many problems with my console so am struggling to think what could be wrong...